•= option is available		T51SSR	T51SSFR	T51SSAR	T51SSF	T51SSAF
1	Coalescing Filter			•		•
2	Non-Relieving	•	•	•
3	Socket Head Build Screw	•	•	•	•	•
4	5 Micron Filter		•	•	•	•
7	Mounting Bracket	•	•	•
8	Pressure Gauge	•	•	•	•	•
9	Tamper Resistant Cover	•	•	•
10	Low Bleed	•	•	•
11	3/8" Port	•	•	•	•	•

Replace the last three digits of the part number with digits from the table below. If more than 2 combination needed, Consult Factory.
OPTION		1	2	3	4	7	8	9	10	11
1	Coalescing Filter	001	021	031		071	081	091	101	111
2	Non-Relieving		002	032	042	072	082	092		112
3	Socket Head Build Screw			003	043	073	083	093	103	113
4	5 Micron Filter				004	074	084	094	104	114
7	Mounting Bracket					007	087	097	107	117
8	Pressure Gauge						008	098	108	118
9	Tamper Resistant Cover							009	109	119
10	Low Bleed								010	110
11	3/8" NPT Port									011

Coalescing Filter: Replaces the 40 micron filter for both moisture and particulate filtration. (Type 51SSAR & Type 51SSAF only) P/N 010-312-000
Non-Relieving: Used in applications where it is desirable to relieve pressure downstream and not at the regulator. Non-relieving regulators should not be used for low or no flow applications.
Socket Head Build Screw: Socket head build screws are provided in place of phillips drive screws.
5 Micron Filter: Replaces the 40 micron filter for more complete air filtration. (Except Type 51SSR) P/N 836-000-002
Mounting Bracket: 316 Stainless Steel bracket for side mounting. P/N 607-000-128
Pressure Gauge: Dual scale (psi / kPa) 21⁄2" (63mm) gauges. Ranges include 0-60 psi (0-410 kPa), 0-100 psi (0-690 kPa) and 0-200 psi 0-1400 kPa). When specified with regulator, the correct range will be supplied.
Tamper Resistant Cover: A 316 stainless steel hexagonal cover placed over the adjusting screw and threaded onto the bonnet of the regulator with a wrench, prevents ordinary hand adjustments.
Low Bleed Diaphragm: (Soft Relief Seat): Used in applications where it is desirable to minimize the standard bleed rate of the regulator while maintaining the ability to relieve excess pressure at the regulator. (Bleed rate is reduced from less than 6 SCFH (2.8 LPM) to less than 0.1 SCFH (0.05 LPM).